Rock-It (SS 150) Lead Section, 3′ (914 mm) long with 8″ (203 mm) – 10″ (254 mm) Helices.
The ROCK-IT™ lead section by Hubbell Power Systems is an innovative solution to help penetrate thin rocky layers without pre-drilling. The single carbide tip design was developed after site testing of several rock anchor configurations to provide an economical, yet proven solution to reach load-bearing depths.

Square Shaft Lead Sections are assembled to Square Shaft Extension with through bolt.
The helical shaped plates do not auger into the soil but rather screw into it with minimal soil disturbance
Hot dipped galvanized per ASTM A153
Capacity of anchor can be determined by measuring installation torque

Category:

Description

Product Details
General
Application Helical Anchoring
Coating Galvanized, ASTM A-153
Number of Helices 2
Strength Note Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength 70000 lb.
Torque Rating 7000 ft-lbs
Type Lead Sections
UPC 096359625704
Dimensions
Anchor Helix Diameter(s) 8 in – 10 in
Dimensions 36.000 in x 10.000 in x 10.000 in
Height 10.000 in
Length 36.000 in
Weight 14.865 lb
Width 10.000 in
Logistics
Standard Package 1

Reviews

There are no reviews yet.

Be the first to review “Anchor, Lead, SS150, 8/10 X 3ft Rock-It”

Your email address will not be published. Required fields are marked *