Square Shaft (SS 225) Lead Section Rock-It, 5′ (1524 mm) long with 8″ (203 mm) – 10″ (254 mm) -12″ (304 mm) Helices.
The ROCK-IT™ lead section by Hubbell Power Systems is an innovative solution to help penetrate thin rocky layers without pre-drilling. The single carbide tip design was developed after site testing of several rock anchor configurations to provide an economical, yet proven solution to reach load-bearing depths.
Square Shaft Lead Sections are assembled to Square Shaft Extension with through bolt.
The helical shaped plates do not auger into the soil but rather screw into it with minimal soil disturbance
Hot dipped galvanized per ASTM A153
Capacity of anchor can be determined by measuring installation torque
Product Details
General
Application Helical Anchoring
Coating Galvanized
Number of Helices 3
Strength Note Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength 200000 lb.
Torque Rating 21000 ft-lbs
Type Lead Sections
Dimensions
Anchor Helix Diameter(s) 8 in – 10 in – 12 in
Length 66.000 in
Reviews
There are no reviews yet.